Ross Racing Engines’ Tony Lombardi cut the valve reliefs using an end mill and his adjustable piston vise. Build, text and photos by Mike Mavrigian The Pontiac bigblock build (starting with a 455 block and boring/stroking to 501 CID) is progressing. I apologize for the time delay, but this build has been [...]
Build, text and photos by Mike Mavrigian . I realize it’s been a while since my last posting of this project’s Part 1 article, but I’ve been tied up with multiple projects at the same time. Since the Part 1 article, I’ve obtained the crankshaft, had the heads finish-machined and assembled [...]
WE BEGIN THE BUILD OF A BORED STROKED PONTIAC 455 TO OBTAIN 501 CID AND ABOUT 600 PONIES. THE GOAL:TO CREATE AN IDEAL “INDIAN” POWERPLANT FOR STREET, STRIP AND STREET RODDER APPLICATIONS Prior to block machining, the block exterior was smoothed and detailed. Not only will this ressurected Pontiac provide some ground-pounding thump, but it’ll [...]
The flattie, adorned with chrome plated headers from Red’s Headers. These pipes fit like a dream. I thought I’d provide an update with regard to both the Ford flathead build (which has already appeared as a 5-part series on precisionenginetech.com and in the latest issue of Hot Rod & Restoration magazine), as well as [...]
For 2011, I’ve decided to produce two new engine projects, each of which will provide handy and informative tips for our readers. Naturally, each build will be presented in our normal manner…as a multi-part series of technical articles. The new projects for this year include a Pontiac 455 and a “Budget LS” build.
The twin water pumps have been chromed and the Tuff Stuff alternator is in it’s final home. . THE ALTERNATOR SETUP Build, text and photos by Mike Mavrigian One of the final additions to this build concerns the alternator and the belt drive. The original engine featured a large generator that was mounted to [...]
Build, text and photos by Mike Mavrigian It’s time to talk about the fuel system on our little 8BA. I chose a triple-deuce setup, using three Barry Grant Demon 98 2-bbl carbs. The center-mounted carb serves as the primary carburetor (P/N 9801), and the front and rear carbs serve as secondaries (P/N 9802). The [...]
THE DYNO RUN Build, text and photos by Mike Mavrigian . Well, we finally ran this engine on dyno. The dyno location was Platinum Engine Designs in Norwich, Ohio, a clean-as-a-whistle top-notch race engine shop in southeast Ohio, equipped with a late-model SuperFlow engine dyno.
The final product is a bit more enhanced than the in-progress photo shown here. I’ll discuss our chrome water pump upgrade, the final custom alternator setup and the complete fuel system setup in the next article. ….. This installment of our Ford Flathead series discusses the timing cover/distributor housing, setup and installation of the MSD [...]
She’s done. In this article, we’ll cover crankshaft balancing, valvetrain and crankshaft assembly. How do you like the plug wire routing? I’ll cover this in a later article installment. I’m considering having the water pump pulleys polished and chrome plated. By the way, the water pump/alternator belt pulley alignment is perfect. If the belt looks [...]
Subscribe to Precision Engine
Sign up for our E-newsletter