BUILDING A STROKER 427 FE After salvaging an original, well-worn 1966 Ford 427 side-oiler block, we begin to build a 485-cube big-dog. Bigger bore and longer stroke…whoof whoof! by Mike Mavrigian all photos by author ENGINE HISTORY/GENERAL INFO The Ford 427 “side oiler” motor was produced from 1963 through 1967, and was used in a [...]
Today’s CAD programs offer definitive X-, Y- and Z-axis depictions of specific blocks, providing you have access to these programs.
All main studs are installed finger-tight, with just an added scooch to make sure they’re seated. The main caps slid on easily, with no stud splaying interference. Be careful when installing the main caps. Each cap is numbered for location, as is the block. Be sure to install caps with cap numbers on the same [...]
LS PROJECT, PART 2 BLOCK PREP AND BALANCING by Mike Mavrigian all photos by author We swapped out the OE torque-plus-angle main cap bolts for a set of ARP studs. This will provide added strength and will eliminate wear on the block’s female threads during future servicing. I recently visited Gressman Powersports where Scott Gressman [...]
Subscribe to Precision Engine
Sign up for our E-newsletter