THE DYNO RUN Build, text and photos by Mike Mavrigian . Well, we finally ran this engine on dyno. The dyno location was Platinum Engine Designs in Norwich, Ohio, a clean-as-a-whistle top-notch race engine shop in southeast Ohio, equipped with a late-model SuperFlow engine dyno.
The final product is a bit more enhanced than the in-progress photo shown here. I’ll discuss our chrome water pump upgrade, the final custom alternator setup and the complete fuel system setup in the next article. ….. This installment of our Ford Flathead series discusses the timing cover/distributor housing, setup and installation of the MSD [...]
I’ve decided to have the water pumps and pulleys polished and chrome plated. This will provide additional visual appeal. Engine build, text and photos by Mike Mavrigian In this series installment, I’ll discuss final installation of the rods and pistons, the oil pump and pan, timing cover, water pumps and cylinder heads.
She’s done. In this article, we’ll cover crankshaft balancing, valvetrain and crankshaft assembly. How do you like the plug wire routing? I’ll cover this in a later article installment. I’m considering having the water pump pulleys polished and chrome plated. By the way, the water pump/alternator belt pulley alignment is perfect. If the belt looks [...]
All that’s left is to install the velocity stacks, finish the spark plug wiring and to fabricate an adjustable mount for the alternator. by Mike Mavrigian, Editor OUR FORD FLATTIE Here’s an update on the ongoing build of our Ford Flathead 8BA. I’ve been holding off the start of the article series until the engine [...]
Our build is done. See the end of this article for several tasty photos of the finished engine, followed by a complete list of the participating manufacturers. FINAL ASSEMBLY OF OUR NASTY LITTLE DART 427W OUR ONE TRICK PONY IS DONE. WE’RE READY FOR THE DYNO RUN. Engine build, text and photos by Mike [...]
FROM SHORTBLOCK TO LONGBLOCK CYLINDER HEADS & VALVETRAIN Our beasty 427W is finally in longblock form. Engine build, text and photos by Mike Mavrigian The use of studs, as compared to bolts, provides a more accurate and consistent clamping load for the cylinder heads, and eliminates wear & tear on the block’s threaded [...]
by Mike Mavrigian Build/assembly and all photos by author Our Lunati roller cam features 0.544″ valve lift at intake and 0.560″ at exhaust, with duration of 232 intake and 242 exhaust. Centerline is 108 intake and 116 exhaust. CAMSHAFT AND TIMING Dart thoughtfully provided anti-friction-coated cam bearings with their block. Each bearing is [...]
Following years of extensive R&D, the engineering team at ARP® has developed a revolutionary new high performance fastener assembly lubricant that is superior to commonly used oil, moly and other lubes. ARP Ultra-Torque® allows builders to torque fasteners within 5% of their required preload on the first “pull,” virtually eliminating “preload scatter,” and ensures [...]
One of the newest releases from HP Books is High Performance Fasteners & Plumbing, written by Mike Mavrigian. This 170-page book provides detailed, yet easy-to-read technical information on understanding all types of performance fasteners (bolts, nuts, screws, rivets, clamps, etc.) and performance plumbing for fuel, brake, oil and coolant hose, fittings, tubes, etc.
Subscribe to Precision Engine
Sign up for our E-newsletter